Minuit Une IVL PHOTON, Service Manual, Page: 37 / 63

IVL™ Photon Service Manual AA 37
9.3
Note the MT1-000614 rubber seal
under the MT1-000404 central tower
module.
When putting it back in position, make
sure to put the seal first in its place,
and then place the central tower
module on top of it.
9.4
When putting back the module, also
be
careful not to squeeze
harness/wiring. They must be well
positioned in the slot like on the
opposite image.
Don’t forget the washer, and tighten
screws with a torque of 1.4 Nm.
After assembling back the fixture you
may have to do a set up plate
calibration (See section
CAL1:
).