MINOLTA-QMS magicolor 330, Service Manual

Page: 53 / 132

magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-49
7.1 Disassembly and Reassembly Procedures (DRP)
This section contains the Disassembly and Reassembly Procedures for major parts and subsystems within the
Large Capacity Input Feeder.
7.1.1 Preparation
Before you begin any LCIF Removal and Replacement Procedure:
1. Switch OFF the printer power.
2. Disconnect the AC power cord from the wall outlet.
3. Wear an electrostatic discharge wrist strap to protect sensitive printer PWBs from damage.
7.1.2 Work Note
Names of parts that appear in the DRPs may not be exactly the same as the names appear in the Parts List.
For example, a part called the Metal Registration Roll in an DRP may appear on the Parts List as Registration
Metal Roll.
Always reinstall the correct type and size screws. Using the wrong screw can damage tapped holes. Do not
use excessive force to either remove or install a part.
7.1.3 Notations in the DRP text
• Locations, such as R or right, given in the DRPs assume you are facing the printer console panel.
• The notation "rear" of a component refers to the side of the component that is, when installed, facing the
rear of the print engine.
• The notation "front" of a component, in place or removed, refers to the side of the component that is, when
in stalled, facing the front of the print engine.
• The notation “(DRP X.Y)” in a DRP step, directs you to another DRP for information on how to perform a
related or pre-requisite procedure.
• The notation “(Figure X.Y)” points to the illustration that corresponds to the DRP you are performing.
• The notation “(PLX)” indicates that this component is listed in the PLX parts list.
• Arrows in an illustration show direction of movement when removing a component.
• Slashes in a part name indicate that numerous components share the same heading and function. For
example, "Gears In/Feed/Out" refers to Gear In, Gear Feed, and Gear Out.
RS1711XB
Rear
Right
Left
Front