MINOLTA-QMS magicolor 330, Service Manual

Page: 34 / 132

LCIF-30 magicolor 330 Large-Capacity Input Feeder Service Manual
4.4 Error Message: Adjust OPT2 Bin
There is a problem with OPT2 Bin.
Logic control on the MCU PWB did not detect a Paper Tray installed i OPT2 Bin.
Step Actions and Question Yes No
SUSPECT COMPONENTS
The following components are associated with this specific
problem. One or more of these components may have failed
partially or completely. If you cannot isolate the problem using
this FIP, replace each component listed below, one at a time,
until the problem disappears.
• Wiring and connectors linking the LCIF to the Base Engine
• Wiring and connectors linking the components
1
PAPER TRAY INSPECTION
1. Remove the Paper Tray from OPT2 bin.
2. Inspect the Size Actuators at the rear of the Tray.
Are the Actuators intact and free of damage?
Go to step 2 Replace the
Paper Tray.
2 Replace the OPT2 bin Size Switch Assembly (LCIF DRP 6.13)
Does the error message still appear?
Go to step 3 Problem
solved
3
Replace the Feeder PWB (LCIF DRP 6.10)
Does the error message still appear?
Go to step 4 Problem
solved
4
Replace the MCU PWB (Base Engine DRP 6.123)
Does the error message still appear?
Go to sus-
pect compo-
nents Problem
solved