mOUnTIng OPTIOns
The user has the option of stowing with the prop orented in or out to accommodate dif erent boat cover coni gurations. Follow the
procedure below to change prop orientation.
1. Turn power on and deploy motor using the stow/deploy button on footpedal or remote (see the Manual Control section or Ulterra
Functions for deploying instructions).
CAUTION:
When deploying, ensure the motor doesn’t contact boat or trailer.
2. Turn the motor of .
3. Pull out manual trim release handle located on the side of trim housing. (Figure 9)
4. While holding trim release handle, lift up shaft/trim housing and rotate 180 degrees. (Figure 10)
5. Lower shaft and trim housing onto the steering housing. Seat trim housing by holding out manual trim release handle and orienting
trim housing onto steering housing. (Figure 11)
6. Turn on power at the motor power button.
7. Stow the motor using the stow/deploy button on footpedal or remote. The lower unit will stow with the prop in the desired
orientation. (Figure 12 & Figure 13)
WARNING: When raising/lowering motor or operating the tilt mechanism, keep fi ngers clear of all
hinge and pivot points and all moving parts.
Figure 10
Figure 11
Figure 9
Figure 12
PROP OUT
Figure 13
PROP In
Trim Handle
minnkotamotors.com | 11
©2014 Johnson Outdoors Marine Electronics, Inc.
InsTALLATIOn