6. Reinstall the extension damper with the shaft facing toward the interior of the boat. Reinstall the e-clips. (Figure 7)
7. Replace the sideplates and sideplate screws by hand using a Phillips screwdriver. (Figure 8)
Note:
Do not use a power tool
to install these screws.
8. Connect the motor to power and sonar cable to depth fi nder using the appropriate adapter cable (sold separately).
Figure 5
Figure 6
Figure 8
Figure 7
1/4” Clipped
Washer
(fl at side facing
mounting base)
1/4” Flat Washer
Rubber Mounting Washer
1/4-20 x 2”
Screw
1/4-20 Nylock Nut
Shaft Side of Damper
1/4-20 x 2” Screw with
1/4” Clipped Washer
(fl at side facing mounting base)
5. Mount the motor to the boat using the provided hardware. Install the hex head bolts and clipped washers on the right side of
the motor as viewed from the boat interior. (Figure 5) Motor can then be slid into place utilizing the slots on the motor base
plate. Clipped washer should be oriented with the fl at portion against the mounting base. (Figure 6)
minnkotamotors.com
Figure 7
Figure 8
10 | minnkotamotors.com
©2014 Johnson Outdoors Marine Electronics, Inc.
InsTALLATIOn