USING THE COPILOT
14 | minnkotamotors.com
©2015 Johnson Outdoors Marine Electronics, Inc.
AUDIO MODES
There are three receiver audio modes available. The unit is factory set to Audio Mode 2. To switch from one audio mode to
another, simultaneously press and hold the increase and decrease speed buttons for one second. The receiver will respond with
1, 2 or 3 audible beeps indicating the corresponding receiver audio mode change.
• Audio Mode 1 = All of the normal audible sounds mentioned in this owners manual, but no audible beeps for
speed increase / decrease or prop on / off .
• Audio Mode 2 = Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off .
• Audio Mode 3 = Same as audio mode 2 plus the prop on audible click every few seconds.
NOTE:
When the corded foot pedal is in control and the propeller is on, the prop on indicator click will be heard if the receiver is
set to audio mode 3.
AUDIO PATTERN
WHAT CONDITION CA
USES
IT
OCCURS IN WHICH AUDIO MODE
1 Beep
Pressing the INCREASE SPEED or DECREASE SPEED
button.
Modes 2 and 3
1 Beep
Pressing the PROP ON/OFF button to turn the prop on.
Modes 2 and 3
2 Beeps
Pressing the PROP ON/OFF button to turn the prop off .
Modes 2 and 3
Single tick every 1.5 seconds When the prop is active including when speed is set to 0.
Mode 3
1 Beep
Switching to audio mode 1 (pressing the INCREASE SPEED
and DECREASE SPEED simultaneously for 1 second).
All
2 Beeps
Switching to audio mode 2 (pressing the INCREASE SPEED
and DECREASE SPEED simultaneously for 1 second).
All
3 Beeps
Switching to audio mode 1 (pressing the INCREASE SPEED
and DECREASE SPEED simultaneously for 1 second).
All
1 Chirp
Every time the receiver is powered up and there is at least one
remote ID learned.
All
2 Second long beep
Every time the receiver is powered up and there are no remote
IDs learned.
All
5 Beeps
Foot pedal speed control is moved after speed has been
adjusted with remote.
All
Steady tone
Heard while holding down the learn button on the receiver.
All
4 Beeps
After a remote button is pressed while the receiver learns its
ID.
All
Ten second warbling sound
that transitions into a steady
tone
Heard during the process used to clear all stored remote IDs.
After the learn switch is released, a 2 second long beep will be
heard.
All
1 Long beep, 2 short beeps,
pause (repeat)
Powered up with MOM/CON in the CON (or MOM switch
held) when foot pedal is moved to momentary, the power up
audio will be heard.
All
