1 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
MKA-16-03 ELECTRIC-STEER
QUICK RELEASE BRACKET
1854035
MOUNTING CONSIDERATIONS
TOOLS AND RESOURCES REQUIRED
Item /
Assembly
Part #
Description
Qty.
A
Includes
2-10
2990114
QCK REL PLATE/THUMB SCREW ASM
1
2
✖
PLATE-MNT,TOP PD QUICK RELEASE
1
4
✖
PLATE-MNT,BTM PD/AP QK/RL
1
6
2373421
SCREW-5/16-18 X 3/8 SHCS S/S
1
8
9951778
LOCKWASHER-1/4" ZINC
1
10
2011385
SCREW-TENSION/NEW KNOB
1
p
2374914
INSTR SHEET-PD/AP QK RL BRK
1
B
Includes
12-18
2994932
BAG ASM, ELEC. STEER QRB
1
12
2371728
WASHER-FENDER 1/4 X 1 1/4 ZP
4
14
2373413
SCREW-1/4-20 X 7/8 HHCS ZP
4
16
2263104
NUT-1/4-20 NYLOCK ZP
8
18
2373516
BOLT-1/4-20 X 2" HHC ZP
4
2
2
6
6
8
8
10
10
4
4
A
A
B
B
14
14
18
18
12
12
16
16
• #3 Phillips Screwdriver
• Drill
• 9/32” Drill Bit
• Awl or similar marking tool
• 7/16” Box End or
Open End Wrench
• A second person to help
with the installation
It is recommended that the motor be mounted as close to the
centerline or keel of the boat as possible. The motor must not
encounter any obstructions as it is lowered into the water or raised
into the boat when stowed and deployed. Make sure the motor rest
is positioned far enough beyond the edge of the boat. Make sure
the area under the mounting location is flat, clear to drill holes and
install nuts and washers. Recruit a second person to help with the
installation, as an unsecured motor will tip when deployed and
when left unattended.
p
Not shown on Parts Diagram.
✖
This part is included in an assembly and cannot be ordered individually.
For use with all Minn Kota® PowerDrive™, Pontoon PowerDrive™, Ulterra™ and Terrova® freshwater trolling motors, the PowerDrive™ Pontoon
Hand Control Bracket and the DeckHand 40.
NOTICE:
Images are a graphical representation and may
vary slightly from your motor.
NOTICE:
In order for the MKA-16-03 bracket to be engaged
and disengaged, the motor must be in the stowed position.
Complete Typical Installation
NOTICE:
The mounting surface for the Bottom Plate must
be completely flat. Rubber Washers can be used to shim
the Bottom Plate flat before hardware is tightened.
