Mini COOPER SE, Owner'S Manual

Page: 146 / 286

Resetting the system
Via the Central Information Display (CID):
1. "My MINI"
2. "Vehicle status"
3. "Tire Pressure Monitor"
4. Switch on drive-ready state and do not
drive off.
5. Reset tire inflation pressure: "Perform
reset".
6. Drive away.
The wheels are displayed in gray and the
following is displayed "Resetting Tire
Pressure Monitor…".
After a travel time of several minutes, the
set tire inflation pressures are accepted as
reference values. The resetting process is
completed automatically while driving.
After successful completion of the reset, the
tires appear in green on the Control Display
and "Tire Pressure Monitor active. See label
for recommended pressures." is displayed.
You may interrupt this trip at any time.
When you continue the reset resumes auto-
matically.
Messages
General information
A low tire inflation pressure may cause the
DSC Dynamic Stability Control to be
switched on.
Safety information
Warning
A damaged regular tire with low or miss-
ing tire inflation pressure impacts han-
dling, such as steering and braking re-
sponse. Run-flat tires can maintain limited
stability. There is a risk of accident. Do not
continue driving if the vehicle is equipped
with normal tires. Follow the information
on run-flat tires and continued driving
with these tires.
If a tire inflation pressure check is
required
Message
A symbol with a Check Control message ap-
pears on the Control Display.
Symbol Possible cause
The system has detected a
wheel change, but no reset was
done.
No reset was performed for the
system. The system issues a
warning based on the tire infla-
tion pressures stored during the
last reset.
Inflation was not carried out ac-
cording to specifications.
The tire inflation pressure has
fallen below the level of the last
reset.
Measure
1. Check the tire pressure and correct as
needed.
2. Reset the system.
If the tire inflation pressure is too low
Message
A yellow warning light is illuminated
in the instrument cluster.
In addition, a symbol with a Check Control
message appears on the Control Display.
Seite 146
CONTROLS Safety
146
Online Edition for Part no. 01405A02680 - II/20