3.2.3
Automatic mode functions:
#
Name
Descriptions
10
Sweep Mode
When selected, allows setting an attenuation sweep with user defined start,
stop, step and dwell time values.
11
Hop Mode
When selected, allows setting a table of user defined attenuation and dwell
time which the attenuator will "hop" through.
12
Continuous
When selected, the attenuator will repeat the user defined sweep or hop until
the Stop button is clicked.
13
Duration
When selected the attenuator will repeat the user defined sweep or hop
sequence for the time specified (can be defined in milliseconds, seconds,
minutes or hours).
14
No. of Cycles
When selected the attenuator will repeat the user defined sweep or hop
sequence for the number of cycles specified.
15
High Speed
(only available with Firmware Rev. B1 or greater) Enables high speed Sweep
and Hop functions. See
section 3.4.3
for details
16
PC control
Default setting. Sweep and Hop instructions are sent individually to the unit
See
section 3.4.2
for details.
17
Bidirectional
When selected, the attenuator will sweep or hop through the user defined
sequence, then repeat in the reverse direction (sweeping from stop to start or
hopping from last to first point in the hop list).
18
Start & Stop
Start and Stop the automatic run (Sweep or Hop) at the current attenuation
setting.
19
Icons
In Hop mode allows clearing all current settings, opening a file of saved
settings or saving current settings. Not available in Sweep mode.
Page 20 of 31
AN-49-005 Rev.:
D
(August 7, 2016) M156027 (R90553) File: AN-49-005(D).doc
This document and its contents are the property of Mini-Circuits
