Checking additional weights then both limits must be a positive value.
Checking removed weights then both limits must be a negative value.
Using "Zero Check" then the high limit is a positive and the low limit is a negative value.
Weight
The previous low limit is also displayed on Display-PW.
On the Display-Count this number of pieces is also shown blinking. The Yellow
LED is on.
2.
Enter a number of pieces via the key pad or a scanner which then is displayed on
Display-Count.
The input value isn’t blinking. Only the actual cursor position (marked by an
under line) is blinking. Input starts from the right side.
3.
Accept the input by pressing
(Yes) Button briefly.
[SET.HI] is displayed on the Display-Weight.
Weight
The previous high limit is also displayed on Display-PW.
On the Display-Count this number of pieces is also shown blinking. The Red LED
is on.
If
(Back) Button is pressed briefly then the input is rejected → the limit
isn’t changed.
4. Enter a number of pieces via the key pad or a scanner which then is displayed on
Display-Count.
The input value isn’t blinking. Only the actual cursor position (an under line) is
blinking.
5.
Accept the input by pressing
(Yes) Button briefly or press the
Button
then the input is rejected.
Count
But if there is an error because e.g. high limit < low limit the Display-Count shows
[LIM.ERR] for about 2 seconds then go back to step 1.
The normal Counting mode is active again. Additional the Check LEDs are active
if the pan is loaded.
If the limit conditions are correct then Check Weighing is initialized.
6 Application Programs
Compact Scale Puro® Count
Minebea Intec
EN-27
