Mine Site Technologies MP70 MinePhone, Administrator'S Manual, Page: 49 / 72

# roamscan.scan.dwell.passive=150
# roamscan.scan.beacon.miss=10
Values Description Field
-90 to 0 where -90 is no
signal. When the RSSI is lower than the defined
value, the phone will roam for an AP that
has a better signal. roamscan.roam.threshold
Default setting is 15. When looking for another AP, if an AP is
found with a RSSI this far above the current
RSSI, the phone will switch across to it. roamscan.roam.floor
True or False. Default
setting is false. Perform more aggressive switching between
APs. This value is not recommended to be
changed. roamscan.aggressive
-90 to 0 where -90 is no
signal. If the signal is lower than the defined value,
the phone will start scanning for other access
points roamscan.scan.threshold
units is in seconds The time period between scans. roamscan.scan.period
0-65535 (seconds). If = 0 the
phone uses the reset value. If When the phone is not connected to an AP,
this is the minimum interval between scans
for an AP. roamscan.scan.foreground.start
= 655635, the phone disables
foreground scanning.
0-65535 (seconds). If = 0 the
phone uses the reset value. The maximum time period (in seconds) the
phone waits for foreground scans to find a
new AP. When the phone is not connected roamscan.scan.foreground.end
to an AP this is the maximum interval
between scans for an AP. The phone will
start scanning at an interval of
roamscan.scan.foreground.start and back off
its subsequent scans until it gets to
roamscan.scan.foreground.end.
Recommended value is 60
seconds. 0-65535 seconds Interval (in seconds) between AP scans
when the phone is connected to the network roamscan.scan.background.period
but if 0 or 65535 is selected and the RSSI is greater than the
roamscan.scan.threshold.
background scanning will be
disabled.
0-65535 (milliseconds). The
recommended setting is 5
(milliseconds). Minimum amount of time (in milliseconds)
to scan a wireless channel. roamscan.scan.dwell.active.min
0-65535 (milliseconds). The
recommended setting is 30
(milliseconds). Maximum amount of time (in milliseconds)
to scan a wireless channel. roamscan.scan.dwell.active.max
Recommended setting is 150
(milliseconds). Amount of time (in milliseconds) that the
phone remains on a channel when listening
for beacons. roamscan.scan.dwell.passive
Recommended setting is 10
(10 beacons = 1 second total) How many beacons are missed by the
MinePhone on the current AP before it will
roam for another AP. roamscan.scan.beacon.miss
Handset Settings
This section configures general phone settings.
MP70 MinePhone Administrator Guide 49 Revision A
Trivial File Transfer Protocol (TFTP) Configuration