4
SYMBOLOGY
Volts
Direct Current
Solid Light -
Single Sequential Actuation
Flashing Light -
Contact (Bump) Actuation
Read Operator's Manual
Wear Eye Protection
Keep Hands Away
C
US
UL Listing for Canada and U.S.
FUNCTIONAL DESCRIPTION
3
4
10
5
1. Hook
2. Trigger
3. Handle
4. Power/Actuation
selection
5. Nail slot
6. LED
7. Magazine
8. Pusher
9. Pusher release
button
10. Workpiece contact
11. Depth adjustment
12. Jam latch
1
2
12
11
7
6
8
9
9
Cat. No. 2740-20
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe
-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Installing/Removing Fastener Strips
(Cat. No. 2741-20, 2742-20, 2743-20)
WARNING
Always remove battery pack before
changing or removing fasteners.
Always wear safety goggles or glasses with side
shields.
Keep fingers clear of fastener track of magazine.
Pusher could pinch fingers, causing injury.
To
install
fastener strips:
1. Remove battery pack.
2.
WARNING!
Always point the tool away from yourself
and others when installing fasteners. Failure to do
so could result in injury.
3. Slide the fastener strip into the nail slot and down
toward the front of the tool. Be sure the point of the
fasteners is pointed downward.
WARNING!
Use only
recommended fasteners of the correct size, length,
collation angle and head type as indicated on the
tool's nameplate.
Other fasteners could result in tool
malfunction, leading to injury.
4. Press and hold the pusher release button and slide
the pusher back past the end of the fastener strips.
5. Continue to hold the pusher, but release the button.
Slowly slide the pusher forward until it rests against
the fastener strip.
To
remove
fastener strips:
1. Remove battery pack.
2.
WARNING!
Always point the tool away from yourself
and others when installing fasteners. Failure to do
so could result in injury.
3. Press and hold the pusher release button and slide the
pusher towards the front of the tool. Release the pusher.
4. Slide the nails back and out of the nail slot.
Installing/Removing Fastener Strips
(Cat. No. 2740-20)
WARNING
Always remove battery pack before
changing or removing fasteners.
Always wear safety goggles or glasses with side
shields.
To
install
fastener strips:
1. Remove battery pack.
2.
WARNING!
Always point the tool away from yourself
and others when installing fasteners. Failure to do
so could result in injury.
3. Press the pusher release button and slide the maga
-
zine open. Place the tip of the fasteners into the bottom
slot of the magazine; then lay the fasteners flat against
the magazine. The heads must fit into the grooves.
WARNING!
Use only recommended fasteners of the
correct size, length, collation angle and head type
as indicated on the tool's nameplate.
Other fasten-
ers could result in tool malfunction, leading to injury.
4. Slide the magazine closed.
