4
Accessory Arbor
Type
Use adapter with this side
facing accessory
adapter not needed
adapter not needed
adapter not needed
adapter not needed
* Adapter kit available as
an accessory. Always use
installation guard and accessory
bolt provided with the kit when
using these accessories.
OPERATION
WARNING
To reduce the risk of injury, keep
hands away from the blade and all
moving parts.
Always wear proper eye protection marked to
comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Typical Applications
A large variety of accessories are available for ap-
plications such as sawing/cutting, scraping, and
sanding.
Sawing/Cutting
Install a sawing/cutting blade at an angle easy to use.
Properly clamp the workpiece. Set the speed dial to
a high speed. Start the tool and allow it to reach full
speed. Use moderate pressure to avoid burning or
scorching the workpiece.
SPECIFICATIONS
Cat. No. ..................................................... 2626-20
Volts
..............................................................
18 DC
No Load OPM
.................................
11,000 - 18,000
Battery Type
.................................................
M18™
Charger Type
................................................
M18™
Recommended Ambient
Operating Temperature
......................
0°F to 125°F
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe
-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specifically
recommended for this tool. Others
may be hazardous.
Changing Accessories
1. Remove the battery pack.
1
2
2. Lift the quick release lever and
push it firmly forward over the
detent.
3. Place the tool upside down on
a flat surface.
4. Unscrew the accessory bolt.
5. Remove any accessories and
adapter.
6. Clean bolt, flange, adapter and accessories of all
dirt and debris.
7. Place the adapter (if necessary), accessory and
bolt onto the tool. Determine the need for an
adapter by using the chart. Hand tighten securely.
8. Press the quick release lever back into place.
Typical
Accessory
Assemblies
