4
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe
-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, lift the battery door latches
and open the battery door. Push in the battery re
-
lease buttons and pull the battery pack away from
the tool. Close the battery door and relatch the door
latches securely.
WARNING
Always remove battery pack before
changing or removing accessories.
To
insert
the battery, lift the battery door latches
and open the battery door. Slide the pack into the
body of the tool. Make sure it latches securely into
place. Close the battery door and relatch the door
latches securely.
WARNING
Only use accessories specifically
recommended for this tool. Others
may be hazardous.
Installing the Base
WARNING
The base should be installed ac
-
cording to the vehicle manufac-
turer's specifications by a qualified technician.
Drilling holes in certain structural areas, or
wiring incorrectly, could compromise the safety
of the vehicle.
To mount the permanent base:
1. Place the base on the desired location. Make sure
it is on a clean, dry surface.
2. Mount the base to the location using four 1/4"
screws.
3. Connect to the vehicle’s wiring per the manufac-
turer’s wiring schematic.
WARNING
Do not use magnet for horizontal
overhead mounting.
To mount the portable base:
Select the best location on your vehicle for the mag-
netic mount. Make sure the metal area under the
magnetic base is flat and clean to ensure a strong
bond.
WARNING!
Excessive force will break the
magnet free. The light should be removed from a
vehicle's exterior while traveling and in strong wind
conditions.
Attaching/Removing the Light
WARNING
Inspect the mounting screw daily
during the required daily vehicle
inspection. If the screw is not tightly secured the
light could detach from the base. A light that
detaches from the base while the vehicle is in
motion is a road hazard and could cause serious
injury or death to others.
The light head can either be attached to the 12V DC
permanent base
or portable base.
To
attach
, secure the light head into the body of the
base with the mounting screw. Make sure the screw
is tightened securely into place.
To
remove
, unscrew the mounting screw from the
body of the base and pull the light head away from
the base.
NOTE:
The 12V DC permanent base and portable
base features a screw hole (M6 x 1 thread) that can
be used to further secure the light head to the base.
FUNCTIONAL DESCRIPTION
10. Mounting
accessories
11. Power leads
12. Remote light
power button
13. Remote on/off
switch
14. Remote joystick
15. Remote mode
button
16. Instensity button
17. Lanyard (not shown)
18. Remote dash mount
4
5
8
2
1
6
3
9
10
11
1.
Light head
2.
ONE-KEY™
indicator
3.
Mode button
4.
Home button
5.
Power button
6.
Portable base
7. Battery
compartment
latches
8. Battery door
9. 12V DC
Permanent
base
12
13
14
15
16
17
18
7
2
