4
1.
2.
The drive control button is
used to adjust the rota-
tion speed (RPM) for
the application.
To select the drive con-
trol mode:
Mode
IPM
RPM
1
to cycle
0-1700 0-1300
2
0-2900 0-3500
3
Pull and release the
trigger to turn on the
tool. The current in-
dicator is lit.
Press the drive control
0-3600 0-4000
button
before changing or removing
accessories. Only use accessories specifically
recommended for this tool. Others may be
hazardous.
To reduce the risk of injury, always wear proper
eye protection marked to comply with
AS/NZS 1337.1.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.
Fuel Gauge
To determine the amount of charge left in the battery,
turn the tool
ON
. The Fuel Gauge will light up for 2-3
seconds. When less than 10% of charge is left, 1 light
To signal the end of charge, 1 light on the fuel gauge
the battery pack.
If the battery becomes too hot, the fuel gauge lights
to cool down.
Using the Drive Control
*In self tapping screw
through the 4 modes.
When the desired mode
indicator is lit, begin
work.
Forward
Push for
Reverse
r
o
f
h
s
u
P
PUSH TO CENTRE TO LOCK
mode, the tool will drive
0-3600* 0-4000*
at full RPM until the screw
taps. Then, for better control, the RPM will slow as
the screw seats to the workpiece.
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the
ON/OFF
switch is not pressed. Always allow the
motor to come to a complete stop before using the
control switch.
ASSEMBLY
WARNING
Recharge only with the charger
-
1. For
forward
(clockwise) rotation, push the control
switch in the direction shown. Check the direction
of rotation before use.
2. For
reverse
(counterclockwise) rotation, push the
control switch in the direction shown. Check the
direction of rotation before use.
s
WARNING
re
Only
co
use accessorie
for thi
mmended
may be hazardous.
s tool. Others
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
the
Always
battery
lock
pack
the
any
trigger
time
or
the
remove
tool
is not in use.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
-
cally designed for use on impact wrenches and
drivers. Other sockets and accessories might
shatter or break causing injury.
Attaching and Removing Accessories
Hex Drive Chuck
shank into the hex drive chuck.
2. To
remove
the accessory, pull out
This driver is intended for use with drill
and driver bits with a 1/4" hex shank and
ball detent recess.
1. To
attach
an accessory, press the
the ring and remove the accessory.
Release the ring.
FUNCTIONAL DESCRIPTION
2
5
6
1
8
3
4
7
1. Trigger
2. LED
3.
4. Drive control
5. Belt clip
6. Fuel gauge
7. Control switch
8. Handle
OPERATION
WARNING
Always remove battery pack
Speed
Indicator
Drive Control Button
Tapping Screw Mode
1/4" Hex
drive chuck