4
OPERATION
WARNING
To reduce the risk of injury, always
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Fuel Gauge
To determine the amount of charge left in the bat-
tery, pull the trigger. The Fuel Gauge will light up for
2-3 seconds.
To signal the end of charge, 1 light on the fuel gauge
will flash for 2-3 seconds.
Using Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha
-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow the
motor to come to a complete stop before using the
control switch.
Push for
Forward
Push for
Reverse
PUSH TO CENTER TO LOCK
1. For
forward
(clockwise) rotation, push the control
switch in the direction shown.
Check the direction
of rotation before use
.
2. For
reverse
(counterclockwise) rotation, push the
control switch in the direction shown.
Check the
direction of rotation before use.
3. To
lock
the trigger, push the control switch to the
center position. The trigger will not work when the
control switch is in the locked position.
Always remove the battery pack before performing
maintenance or changing accessories. Always
lock the trigger or remove the battery pack before
storing the tool and any time the tool is not in use.
Starting, Stopping and Controlling Speed
These tools may be operated at any speed from 0
to full speed.
1. To
start
the tool, pull the trigger.
NOTE:
An LED is turned on when the trigger is pulled.
2. To
vary
the driving speed, simply increase or
decrease pressure on the trigger. The further the
trigger is pulled, the greater the speed.
3. To
stop
the tool, release the trigger.
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe
-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specifically
recommended for this tool. Others
may be hazardous.
Use only sockets and other accessories specifi
-
cally designed for use on impact wrenches and
drivers. Other sockets and accessories might
shatter or break causing injury.
Attaching and Removing Accessories
These tools are intended only for use with acces-
sories designed for impact wrenches and drivers.
Other sockets could shatter or break, causing injury.
(Cat. No. 2462-20)
This driver is intended for use with drill and
driver bits with a 1/4" hex shank and ball
detent recess.
1. To
attach
an accessory, pull the ring out
and insert the accessory shank. Release
the ring. It may be necessary to pull the
bit out slightly to engage the holding
mechanism.
2. To
remove
the accessory, pull out the
ring and remove the accessory. Release the ring.
(Cat. No. 2461-20 and 2463-20)
1. To attach a socket, align the accessory with the
drive shank and push it firmly over the retaining
ring.
2. To remove the accessory, pull the accessory off
the drive shank.
