17
The torque specifications shown here are ap-
proximate values obtained with a fully charged
battery pack.
NOTE:
Because the settings shown in the table are
only a guide, use a piece of scrap material to test
the different clutch settings before driving screws
into the workpiece.
Torque Specifications for Cat. No. 2411-059
Clutch
Setting in. lbs
Applications
1-5
6-10
11-15
16-18
5-15
16-22
23-28
29-40
Small screws in softwood.
Medium screws in softwood or small
screws in hardwood.
Large screws in softwoods. Medium
screws in hardwood or large screws in
hardwood with pilot hole.
Selecting Speed
The speed selector is on top of the motor housing.
Allow the tool to come to a complete stop before
changing speeds. See “Applications” for recom-
mended speeds under various conditions.
1. For
Low
speed (up to 400 RPM), push the speed
selector to display “1”.
2. For
High
speed (up to 1500 RPM), push the
speed selector to display “2”.
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due
to a lockout mechanism, the con-
trol switch can only be adjusted
when the ON/OFF switch is not
pressed. Always allow the mo-
tor to come to a complete stop
before using the control switch.
For
forward
(clockwise) rota-
tion, push in the control switch
from the right side of the tool.
Check the direction of rotation
before use.
For
reverse
(counterclockwise)
rotation, push in the control
switch from the left side of the
tool.
Check direction of rota
-
tion before use.
To
lock
the trigger,
push the
control switch to the center po-
sition. The trigger will not work
while the control switch is in the
center locked position. Always
lock the trigger or remove the
battery pack before performing
maintenance, changing acces-
sories, storing the tool and any
time the tool is not in use.
Starting, Stopping and Controlling Speed
1. To
start
the tool, grasp the handle firmly and pull
the trigger.
NOTE: An LED is turned on when the trigger is
pulled.
2. To
vary
the speed, increase or decrease the
pressure on the trigger. The further the trigger
is pulled, the greater the speed.
3. To
stop
the tool, release the trigger. Make sure
the bit comes to a complete stop before laying
the tool down.
Battery Pack Protection
To protect the battery from damage and extend
its life, the tool’s intelligent circuit monitors current
draw, temperature, and voltage drops.
In extremely high torque, binding, stalling, and short
circuit situations that cause high current draw, the
tool will vibrate for about 5 seconds, the fuel gauge
will flash, and then the tool will turn OFF. To reset,
release the trigger.
Under extreme circumstances, the internal tem-
perature of the battery could become too high.
If this happens, the fuel gauge will flash and the
battery pack will shut off. Let the battery pack cool
and then continue work.
This tool provides a quick, convenient means of
drilling small holes and installing and removing
screws. Because of the many screw sizes, types,
thread engagements and materials available, it is
difficult to limit the application of this tool by screw
size. However, for applications in wood, a #6 wood
screw with a full pilot hole is recommended as a
practical limit.
Forward -
Push from
RIGHT
Reverse -
Push from
LEfT
Lock -
Push to
CENTER
