Milnor TP1607 Series, Installation And Service

Page: 43 / 50

3XUS[Y^W4YQ`XbQW]CXQ`U
Verify the shape of the diaphragm as follows:
Manually raise the platen and secure with safety brackets (FIGURE 1).
Lock off and tag out power to the machine.
Place a ruler across the bottom of the diaphragm as shown in FIGURE 12. Measure the distance
between the middle of the ruler and the bottom of the diaphragm. This distance must be about 70mm.
If the distance is not correct, repeat steps 9 through 12 until the proper measurement is achieved.
Fill
valve
closed Air
relief bolt
closed
Press bed
goods
up
586DA4(
=CC= )$&15
@bU`QbY^Wd_CXQ`UdXU4YQ`XbQW]
Press bed
goods
down
hose
can
586DA4
=CC= )$&15
2UWY^^Y^Wd_CXQ`UdXU4YQ`XbQW]
Press bed
goods
down can
Fill valve
open
586DA4
=CC= )$&15
EcY^W7__Tcd_CXQ`UdXU4YQ`XbQW]Ri@ecXY^WGQdUb
_ed_VdXU4YQ`XbQW]
Fill
valve
closed
Press bed
ruler
70mm
up
586DA4 !
=CC= )$&15
3XUS[Y^WdXU4YQ`XbQW]V_b@b_`UbCXQ`U
C? %&gg?A4BB380?7A06<A4?;024<4=C =CC= )$&15)&#(1F$$
39