Milnor TP1607 Series, Installation And Service

Page: 16 / 50

9^cdQ\\dXU<UfU\6\_Qd1ccU]R\i
This assembly turns the press water return pump on when the press water tank level rises above
high and off when the level falls below low. The assembly may be installed within the frame of the
machine, thus saving space, or outside the frame where it is more accessable. In either case, the assembly
must be mounted on the opposite side of the machine from the press water return pump. Piping and
control wiring are not furnished because the location of the level float assembly can vary.
=_e^dQ^T@\e]RdXU6\_QdDeRU
—Once the location has been determined, mark and
drill four holes in the press corner panel and mount the float tube using the hardware provided.
<^d]cX]V8]bXSTcWT5aP\T
—Let the float tube rest on the bottom of the press water tank.
The float tube will sit in the press water tank and not need a hose connection (see FIGURE 15).
<^d]cX]V>dcbXSTcWT5aP\T
—For outside mounting, connect the 3/4" (19mm) hose
conection on the float tube to the closest 1/2" NPT male conection on the front of the tank.
Provide a 3/4" to 1/2"NPT reducer, 3/4" pipe nipple, 3/4" (19 mm) hose and hose clamps (see
FIGURE 16).
3_^^USdY^W<UfU\CgYdSXUc
—The two level switches are inputs to the press controller.
Wire these as shown in FIGURE 14.
586DA4 $) <UfU\ 6\_Qd =_e^dUT 9^cYTU dXU =Q
SXY^U 6bQ]U
586DA4 %) <UfU\ 6\_Qd =_e^dUT ?edcYTU dXU =QSXY^U
6bQ]U
9>CD1<<1D9?>±D@!& 'hh @B5CC =C9> ) (15)'!#1F ( _V !!
12