![Milnor TP1607 Series Installation And Service Download Page 12](http://html1.mh-extra.com/html/milnor/tp1607-series/tp1607-series_installation-and-service_1797153012.webp)
Each threaded rod now has two nuts above the cylinder
flange which interfere with raising the cylinder
completely. The uppermost nut locks the rod in place.
When the cylinder assembly is within three inches or 75
mm of its final position and the assembly is supported by
all three threaded rods and lower nuts, remove one
threaded rod, as shown in FIGURE 7, remove both top
nuts then replace the rod and lower nut. Repeat for each
of the other two rods, ensuring that the cylinder assembly
is always supported by at least two rods/nuts.
Carefully crank the assembly up the remaining distance
using the nuts on the threaded rods, guiding the machined
lip of the cylinder assembly into the hole and fully seating
the assembly. Six hex head (30 mm) mounting bolts are
furnished. Install three mounting bolts in the three empty
mounting holes, then remove the three threaded rods, and
replace with the three remaining mounting bolts. Torque
all bolts to 550 foot-pounds (76 Nm).
9^cdQ\\dXU8iTbQe\YS1ccU]R\i
The hydraulic power unit was removed from the press
and skidded separately.
=_e^ddXU1ccU]R\i
— An ch o r t he h y dr au l ic
assembly to the mounting frame on top of the press using the
bolts, nuts and washers furnished on the mounting frame.
Four integral lifting eyes are provided on the hydraulic
assembly for crane lifting.
CUddXU@bUVY\\FQ\fU9^@_cYdY_^Q^T
3_^^USddXU@bUVY\\@Y`U
—as follows:
Remove the cylinder protective cover, taking care not to
permit debris from entering the cylinder.
Place the pre-fill valve over the opening, oriented as
shown in FIGURE 8.
Clip the tie wrap securing the pre-fill pipe on the
hydraulic assembly, then lift and rotate it into position
over the pre-fill valve (see FIGURE 9).
Eight Allen head bolts (19 mm) are furnished. Install
these as shown in FIGURE 9 and torque to 250
foot-pounds (35 Nm).
Tighten the hose clamps on the rubber boot on the tank side of the prefill pipe.
586DA4 &) DU]`_bQbY\i BU]_fY^W Q
DXbUQTUT B_T d_ BU]_fU dXU D_` >edc
586DA4 ') @bUVY\\ FQ\fU CUd Y^ @_cYdY_^
586DA4 () @bUVY\\ @Y`U 9^cdQ\\UT
9>CD1<<1D9?>±D@!& 'hh @B5CC
=C9> ) (15)'!#1F $ _V !!
8
Summary of Contents for TP1607 Series
