Milnor 30 Series, Manual

Page: 26 / 208

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 3: Filters, Screens, and Sensitive Components
Remove contamination from these components to prevent damage and unsatisfactory performance.
Mark
1 2 3 4 5 6
Do this each Component
More Data. See also Section 3.1.3 “How
to Remove Contamination”
x 40 to 60 hours inverter fans, vents, filters See Figure 8 . Keep good air flow.
x 600 hours motors Keep good air flow.
x 2400 hours entire machine Remove excessive dust and dirt.
x day* chemical inlet areas Some chemical supplies that stay on machine
surfaces will cause corrosion damage. See
Figure 9 and Section 2.2. “Prevent Damage
From Chemical Supplies and Chemical
Systems”
x 2400 hours strainer in water regulator for
optional supply injector and
pumped chemicals on some
models. See Figure 10
x 200 hours strainer(s) for air inlet See Figure 13
x 200 hours strainer for steam inlet.
(Steam is optional on some
models.) See Figure 12
Table 4: Fluid Containers
Examine. Add fluid if necessary and keep components clean to prevent damage.
Mark
1 2 3 4 5 6
Do this each Component
More Data. See also Section 3.1.4
“Lubricant Identification and Procedures”
x 600 hours bearing housing remove used oil. Add 22 ounces (650 ml) of
oil 30 (
Table 10 ). See Figure 14
Table 5: Components that Become Worn
Examine. Tighten or replace if necessary, to prevent shutdowns and unsatisfactory performance.
Speak to your dealer for replacement parts
Mark
1 2 3 4 5 6
Do this each Component More Data
x 200 hours drive belts and pulleys See Supplement 1 and Figure 7
x 200 hours tubes and hoses Examine hoses and hose connections for
leaks.
x 200 hours rubber springs and shock
absorbers See Figure 16 . It is necessary to replace worn
components. Speak to your dealer or Milnor.
This is not routine maintenance.
22