Millipore Elix 35, User Manual

Page: 58 / 71

Troubleshooting
Elix® 20, 35, 70 and 100 50
5-2 A
N
A
LARM
M
ESSAGE OR
M
AINTENANCE
M
ESSAGE IS DISPLAYED
LCD MESSAGE
WHAT IT MEANS
 WHAT TO DO
ALARM, ALARM STOP
OR MAINTENANCE
MESSAGE?
% REJECTION < SETPOINT The RO % Rejection is below the RO % Rejection Setpoint.
 Verify that the RO % Rejection Setpoint is 92%. Allow the Elix
System to operate for several minutes. This may raise the
measured RO % Rejection.
Programmable – can be
set to any type of
message (Maintenance
by Factory Default).
ACCESS CONFLICT The information on the TAG Sensor was not read correctly during
PACK EXCHANGE Mode.
 Replace the Progard or accept it.
ASM UV LAMP EXCH.
OVERDUE: XX DAYS
The UV Lamp in the ASM Accessory should have been changed XX
days ago.

The message will go away when a new ASM UV Lamp is
installed and its software timer is reset.
Maintenance (Yellow
LED).
BAD PROGARD TYPE The wrong type of pack is being installed.
 Check the type of pack being installed. Contact Millipore SAS
for assistance.
CANNOT ACCESS
CONSUMABLE INFO The information on the TAG Sensor was not read correctly in
PRODUCTION Mode.
 Replace the Progard or accept it.
Alarm (Red LED).
CHECK A10 COM The communication between the A10 TOC Monitor and the Elix
System PC Board is interrupted.

Contact Millipore SAS.
Programmable – can be
set to any type of
message (Maintenance
by Factory Default).
CHECK ASM UV LAMP The UV Lamp in the ASM Accessory is not turning on.
 Contact Millipore SAS.
Programmable – can be
set to any type of
message (Maintenance
by Factory Default).
CHECK ELIX MODULE The voltage or the electrical intensity being supplied to the Elix
Module is out of specification(s).
 Contact Millipore SAS.
Maintenance (Yellow
LED).
CHECK UV LAMP The UV Lamp in the Elix System is not turning on.

Contact Millipore SAS.
Programmable – can be
set to any type of
message (Maintenance
by Factory Default).
CUSTOM ALARM 1 A customised alarm is displayed.

Contact Millipore SAS.
Programmable – can be
set to any type of
message.
CUSTOM ALARM 2 A customised alarm is displayed.
 Contact Millipore SAS.
Programmable – can be
set to any type of
message.