Mikrotron EoSens 12CXP+, Reference Manual

Page: 65 / 88

User Set Control
MIKROTRON GmbH 9 - 2
Introduction
User sets can be saved into the camera’s internal Flash memory. A user set
can be loaded at runtime. If a user set is defined as default, it will be loaded
during the start-up of the camera.
UserSetSelector
This feature selects which user set (up to 3) will be loaded, saved or
configured.
UserSetLoad
Loads the user set specified in UserSetSelector from the camera flash
memory to the camera registers and activates it.
Name Access
Length
[Bytes]
Interface Page
UserSetSelector R/W 4 Enumeration 9-2
UserSetLoad W 4 Command 9-2
UserSetSave W 4 Command 9-3
UserSetDefaultSelector R/W 4 Enumeration 9-3
Access
read/write
Type
enumeration
In
Default
UserSet1
UserSet2
UserSet3
selects the factory settings
selects the first user set
selects the second user set
selects the third user set
Out
active user set
Remark
Set the UserSetSelector first to select a user set for further oper-
ations (see below).
Access
write
Type
command
In
Out
Remark
If the selected User Set has not been defined previously an error
message occurs.
The default user set is a set of factory settings predefined by the
MIKROTRON.