Mikrotron EoSens 12CXP+, Reference Manual

Page: 29 / 88

First Steps
MIKROTRON GmbH 4 - 3
Step 7.
Mount the lens
Step 8.
If an external power supply is used, connect it with the
main supply
Step 9.
Switch-on the image processing system
Step 10.
Check the LED of the camera to verify that the camera
is ready for use. (For more information see "
Status
LED " on page 3-11. )
Power-up Profile
If the camera is powered-up, the power-up profile which is perma-
nently stored in the non-volatile memory of the camera, will be
loaded. This profile consists of a number of camera settings like sen-
sor resolution and frame rate. It is used to bring the camera into a
defined operation mode.
Tip: The camera has NOT to
be configured by the host to
start operation. The power ‐
up profile will deliver all
necessary values.
Serial number and firmware version are provided in the non-volatile
memory of the camera too. Use the GenICam feature DeviceSerial-
Number to read the serial number and the firmware revision. Read
the chapter Bootstrap Registers for more information.
If you need the serial number only, you find it on the identification
plate of the camera.