Installation surface
A concrete floor is the most suitable
installation surface for a washing
machine, being far less prone to
vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
Please note:
^
The machine must be level and
securely positioned.
^
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
^
We recommend a plywood base (at
least 59x52x3 cm). The base should
span several joists and be bolted to
the joists and not only to the
floorboards. Check for the presence
of pipes and cables first.
If possible, install the machine in a
corner, as this is usually the most stable
part of the floor.
,
If the machine is installed on a
raised plinth, it
has to be secured
against slippage during spin using
retaining clips (available from the
Miele Spare Parts Dept). Otherwise
there is the danger of the machine
moving about.
Transporting the washing machine to
its installation site
To manoeuvre the machine out of its
packing case to its installlation site,
hold it by the edge of the lid where it
protrudes to the rear of the machine as
well as by the handle recesses at the
front.
,
Ensure that the machine feet and
the floor are dry to prevent the
machine from slipping during the
spin cycle.
Removing the transit bars
^
To remove the left and right covers
1
. Pull on the attached stopper,
2
. then use a screwdriver to release the
catch at the top.
Installation and connection
63
Summary of Contents for W 5928 WPS EcoComfort
Page 85: ...85 ...
Page 86: ...86 ...
Page 87: ...87 ...
Page 88: ...Alteration rights reserved 1209 W 5928 WPS EcoComfort M Nr 07 484 000 00 ...