Miele W 2653 WPS, Operating Instructions Manual

Page: 38 / 72

Problems with the load size indicator
Problem Possible cause Remedy
There is no load size in
the display. There was already
laundry in the drum
when the washing
machine was
switched on. This
has decalibrated
the sensor from the
zero setting.
^
To recalibrate the sensor to the
zero setting:
– Remove the laundry from the
drum.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
– Press the programme button
for
Cottons Universal.
– Press and hold the
Load/Detergent button until the
following appears in the
display:
Zero setting
OK
.
The display indicates a
load greater than
<25%
when the drum is
empty.
The load size
sensor has been
decalibrated from
the zero position. Rotate the drum once. If the
display still indicates a load
greater than
<25% , recalibrate
the sensor to zero again (see
above section).
If the fault message:
Zero setting
not possible
Empty drum
appears in the display.
The drum door is
closed. – Open the drum door.
– Switch off the washing
machine and leave the door
open.
– Switch on the washing
machine.
–
Try and recalibrate to zero
again.
Problem solving guide
38