Roasting
98
You can also delay the start of the
cooking programme to a later time.
Select the
Start at
option. In Automatic
programmes select
Start later
.
You can estimate approximately when
the food will be ready as the duration of
the cooking programme is about the
same as if you were cooking food
without using the food probe.
You cannot enter a
Duration
or
Finish at
time, as the total cooking duration is
determined by how long it takes for the
core temperature to be reached.
Time remaining display
If the temperature set for a cooking
process is above 140 °C, the estimated
time left for the cooking process will
appear in the display after a short while.
The time remaining is calculated from
the cooking temperature selected, the
required core temperature and the
pattern of the increasing core
temperature.
The time remaining first shown is an
estimate. As the cooking process
continues, the time remaining is revised
continuously, and a more accurate
revised figure shown.
Altering the cooking or core
temperature or selecting a different
function will delete the time left
information. The time remaining will be
recalculated if the door is kept open for
a long period of time.
Displaying the core temperature
As soon as the time remaining appears,
you can also display the actual core
temperature.
Select
Change
.
Select
Display core temperature
.
Select
On
.
Confirm with
OK
.
The actual core temperature will also
appear in the display.
Using residual heat
The heating in the oven switches off
shortly before the end of the cooking
programme. The residual heat in the
oven is sufficient to complete the
cooking process.
Using the residual heat in the oven
saves energy.
Energy save phase
will appear in the
display to show that the oven is in
energy save mode. The measured core
temperature is no longer visible.
The cooling fan continues to run, as
does the hot air fan if a “fan” setting
has been chosen.
When the core temperature selected
has been reached,
–
Process finished
appears in the
display.
– a buzzer will sound if the buzzer is
switched on (see “Settings - Volume -
Buzzer tones”).
Useful tip:
If the food is not yet cooked
sufficiently, insert the food probe into
another place and repeat the
programme.
