Installing the oven
101
The oven must not be operated
until it has been correctly installed in
its housing unit.
The oven must have an adequate
supply of cool air for proper
operation. The required air must not
be heated excessively by other heat
sources, e.g. wood burning stove.
Observe the following when
installing:
Do not fit a back panel in the housing
unit.
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit insulation to the side walls
of the housing unit.
Before installation
Before connecting the appliance to
the mains, you must disconnect the
power supply to the isolator switch or
fused spur connection unit.
Building in
Connect the mains cable from the
oven to the isolator.
Do not carry the oven by the door
handle. The door can be damaged.
Use the handles on each side of the
casing to carry it.
It is advisable to dismantle the door
before installing the appliance (see
"Cleaning and Care - Dismantling the
door") and remove accessories from
the oven cavity. This will make it easier
to install in its niche and you will not
be tempted into using the handle to
carry it.
Push the oven into the housing unit
and align it.
Open the door (if you have not
removed it previously).
Use the screws supplied to secure
the oven to the side walls of the
housing unit through the holes in the
oven trim.
Refit the door, if necessary (see
"Cleaning and care - Refitting the
door").
Summary of Contents for H2561BP
Page 106: ......
Page 108: ...M Nr 10 168 910 04 en GB H2561BP H2661 1BP H2566BP ...