Miele G 7969, Operating Instructions Manual

Page: 125 / 128

Installation
*INSTALLATION*
125
Electrical connection
The dishwasher is supplied with a
mains cable with moulded plug ready
for connection to an earthed socket.
The socket must be easily accessible
after the dishwasher has been installed.
If the switch is not accessible after
installation, an additional means of
disconnection must be provided for all
poles.

Risk of fire from overheating.
Connecting the dishwasher to a
multi-socket plug adapter or to an
extension lead can overload the
cable.
Do not use an extension lead or
multi-socket plug adapter.
The electrical installation and all
electrical work must be carried out by a
suitably qualified and competent person
in strict accordance with national and
local safety regulations. For extra
safety, it is advisable to install a residual
current device (RCD) with a trip current
of 30 mA. Ensure power is not supplied
to the appliance until after the
installation has been completed.
Connection should be made via a
suitable switched socket.
If the mains connection cable is
damaged, it must only be replaced with
a specific mains connection cable of
the same type (available Miele). For
safety reasons, such replacement may
only be carried out by a suitably
qualified and competent technician or
by Miele.
For technical data, see the data plate
located on the right side of the door.
Compare this information with the data
of the on-site electrical connection.
If in any doubt, consult a qualified
electrician.
Do not connect the dishwasher to a
stand-alone inverter such as those used
with an autonomous energy source (e.g.
solar power). When the dishwasher is
switched on, power surges could result
in a safety switch-off. This could
damage the electronics.
The dishwasher must not be used with
so-called energy-saving devices either.
These reduce the amount of energy
supplied to the appliance, causing it to
overheat.