Operation
35
Starting a program
Start the program by closing the door
within four seconds of the last press
of a button.
The program will begin.
If you do not close the door within
four seconds, the indicator lights of
the selected program and the time
display will flash.
The program cannot be started until
you press the program selection but-
ton and close the door within four
seconds.
A program should only be canceled
in the first few minutes, if at all. Oth-
erwise important program stages
could be omitted.
Time display
The duration of the program selected
appears in hours and minutes in the
display before the program begins. Dur-
ing the program, the time left until the
end of the program can only be viewed
when the door is open.
The program duration displayed may
vary with the same program. It is influ-
enced by, among other things, the wa-
ter temperature at each intake, the re-
activation process, the softener assem-
bly, the type of detergent, the amount
of dishes, and the amount of soiling.
When a program is selected for the first
time, the display will show the average
program duration for a cold water in-
take.
The times shown in the program over-
view refer to standard test loads and
temperatures.
Each time a program is run, the elec-
tronic module calculates the program
duration required depending on the
temperature of the water taken into the
dishwasher and the amount of dishes.
Summary of Contents for G 4993
Page 66: ...66 ...
