Midway CART Fury Championship Racing, Operation Manual

Page: 95 / 104

C.A.R.T. FURY T
ROUBLESHOOTING
- 7
PLAYER CONTROL TROUBLESHOOTING
Symptom Cause Required Action
• Intermittent or com-
pletely non-functional
player controls
• Video Game Machine
(VGM) starts normally.
Faulty switches or
lamps 1. Press and hold TEST MODE switch inside coin
door to enter Menu System. Select SWITCH
TEST from Diagnostic Menu. Conduct tests to
confirm switch operation.
2. Press and hold TEST MODE switch inside coin
door to enter Menu System. Select LAMP TEST
from Diagnostic Menu. Conduct tests to confirm
lamp operation.
3. Check for loose parts or wires caught in switch
contacts.
4. Check continuity at each switch connection (Com-
mon to Normally Open or Common to Normally
Closed).
5. Verify player control operates properly by placing it
in working VGM.
6. Verify light bulbs used for dashboard switches are
type specified in parts listing. Other types will light,
but may produce too much heat. Excess heat may
cause switches to bind.
Faulty switch wir-
ing 1. Check for wires caught in door hinges, latches, or
switch contacts.
2. Verify harness connectors are attached and fully
seated.
3. Assure control switches connect properly to con-
trol input wires.
4. Check cabinet wiring is correct for this VGM.
• Steering pulls to one
side
Faulty Wheel
Driver Board 1. Find power amp on Wheel Driver Board’s large
heatsink. Test and replace bad part or board.
• No wheel feedback
• Steering aims vehicle
as expected
Improperly set
feedback 1. Select STEERING WHEEL TEST on the Diagnos-
tics Menu.
2. Set feedback to match player requirements. Maxi-
mum force may be too extreme for very young or
inexperienced customers.
Faulty circuit 1. Examine fuses and cables on Wheel Driver Board.
2. Check cables and wiring between CPU board,
wheel driver and motor.
3. Check resistance of motor series resistors.
4. Replace bad parts.
Faulty motor 1. Turn off power. Open dashboard. Support steering
wheel and remove outer mounting screws.
2. Remove metal shield (if VGM has one) over
motor.
3. Unscrew caps.
4. Inspect motor brushes. Replace worn parts.