Midway CART Fury Championship Racing, Operation Manual

Page: 48 / 104

4 M
IDWAY
A
MUSEMENT
G
AMES
, LLC
C
HAPTER
3 S
ERVICE
SERVICING
Only qualified service personnel should perform maintenance and repairs. The product guidelines apply to
all operators and service personnel. Specific notes, cautions, and warnings appear throughout the manual
where they apply. We recommend that you read the SAFETY NOTICES section thoroughly before begin-
ning service. NOTE: Always switch off power to the game machine before servicing.
To service the Marquee…
Refer to Marquee Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the tamper-resistant screws used to fasten the marquee to the top of the cabinet.
• Lift the marquee straight out from the cabinet and set aside to expose the opening of the cabinet.
• Perform the desired repair or equipment replacement.
• To reinstall, align the contoured marquee with the contour of the cabinet.
• Fasten in place with the screws provided.
M
ARQUEE
S
ERVICE
To service the Backlit Marquee …
Refer to Marquee Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Lift open the Marquee Housing. Refer to service instructions for Marquee.
• Reach up inside the opening toward the marquee artwork. The marquee artwork and marquee glass is
held in place at the top and sides by spacers/brackets fastened with screws.
• Remove the screws from each of the brackets. Set the screws and brackets aside until reinstallation.
• Lift the marquee artwork or marquee glass out of the housing.
• Perform the desired repair or equipment replacement.
To service the Fluorescent Light Assembly…
Refer to Marquee Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Lift open the Marquee Housing. Refer to service instructions for Marquee.
• Reach up inside the opening in the cabinet and disconnect the power cable from the fluorescent light
assembly.
• Loosen, but do not remove the screws fastening the assembly to the cabinet.
• Slide the assembly slightly forward to disengage the keyholes. Lift out the assembly.
• Perform the desired repair or equipment replacement.