Midway CART Fury Championship Racing, Operation Manual, Page: 57 / 104

C.A.R.T. FURY 13
C
HAPTER
3 S
ERVICE
To service the Battery…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear door.
• Remove the screws used to fasten the hinged, metal cage covering the PCB Assembly.
• Open the cage, which is hinged along the bottom edge, to expose the PCB assembly.
• Locate the battery on the Vegas SIO Board assembly, and then remove using a chip extraction tool.
• To install a battery, orient a battery over the corresponding socket and press firmly to seat. NOTE: Do
not force; the battery is notched and will only fit in the socket one way.
To service an Auxiliary Board Assembly…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear door.
• Remove the screws used to fasten the hinged, metal cage covering the PCB Assembly.
• Open the cover, which is hinged along the bottom edge, to expose the PCB assembly.
• Carefully note the orientation of the cables. Extract the harness and other cables from the board connec-
tors.
• Remove the assembly mounting screws. Lift the board out of the cabinet and set in a safe place. Use
anti-static bags and protective containers for storage if not reinstalled immediately.
• Perform the desired repair or equipment replacement.
• Be certain to reinstall the metal cover so that it seals against the metal cage.
To service the Power Supply…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear cabinet door.
• Unplug the IEC AC connector from the rear of the supply and the DC connector from the front.
• Remove the two front and two rear screws from the supply, then lift it off of the power chassis. Note volt-
age setting.
• Perform the desired repair or equipment replacement.
• Be sure to set the voltage switch to the correct value prior to reinstallation.
• Set the supply on the power chassis and align the mounting holes. Install the four screws and the two
power connectors.
To service the Transformer…
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear door.
• If the power to the Video Game Machine (VGM) was only recently disconnected, the transformer may
still be warm. Allow the transformer to cool completely before handling.
• Label and disconnect all wiring, including ground.
• Remove the screws used to fasten the transformer to the base of the cabinet.
• Perform the desired repair or equipment replacement.
CAUTION
Discharge any static electricity built up in your body by touching the chassis for the power
supply. Do this BEFORE touching or handling the electronic assemblies
DANGER
High voltage present. Exercise extreme caution while servicing transformer.