•
8
•
2. Select the
BATTERY TYPE:
12 VOLTS
6 VOLTS
3. Select the battery rating system and rating value as required in
the Out-of-Vehicle Battery Test.
If necessary, the analyzer will ask if the battery temperature is
above or below 32 ºF or whether you are testing before or after
charging. Refer to “ Additional Features” for more information.
Battery Pack Test Results
The Micro700 will display the open circuit voltage, cranking amps
(the units are based on rating system you selected) and a one of five
battery conditions.
NOTE
: The analyzer generates battery codes when you test
individual batteries only.
GOOD BAT. PACK
Compensating for cable and connector resistance, the analyzer has
determined that the battery pack is in good condition compared to its
rating.
CHECK BAT. PACK
Compensating for cable and connector resistance, the analyzer has
determined that the battery pack is in poor condition compared to its
rating. Check the connections and test the batteries separately.
Testing Individual Batteries
At the end of the Battery Pack Test, the analyzer will give you the
option to test the batteries individually. If you choose
YES
, the
analyzer will prompt you through the steps of disconnecting, testing
each battery, and reconnecting the battery pack. The analyzer will
store the test result and battery code for each battery until you start a
new test by connecting to a battery after completing the Battery Pack
Test. Refer to “Battery Test Results” and “Battery Code” in the “Out-
of-Vehicle Test” section.
If you choose
NO
, the analyzer will store the Battery Pack Test
results. If you selected a Full System Test, the analyzer will proceed
to the Starting System Test.
