EN
16
www.midlandeurope.com
(“Bridge” feature disables). See the paragraph “
Bridge and Background
feature
” in the previous pages.
GPS Stereo (A2DP) voice announcement
Midland BTMESH supports Stereo (A2DP) voice announcement from GPS
Navigators or smartphone application only on “Vol+” connection. When
connected on “” button, the GPS street voice announcements are
always active in background during the Mesh communication.
How to pair the Midland BTMESH to a GPS
In general it is possible to pair the Midland BTMESH to all GPS for motorbike
that support Bluetooth headset connection.
To pair the Midland BTMESH to a GPS, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the “Middle” button about 7 sec., until the Red light is
on permanently.
3. Now press firmly (3 sec) the “” or “Volume -” button, the Blue
and Red lights will flash.
4. Enable the Bluetooth device search feature on your GPS
5. After some seconds, “Midland BTMESH” will be displayed on your GPS.
6. Follow the pairing procedure of your GPS. If a pin code is requested you
must enter “0000” (four times zero).
When successfully paired, the Blue light of the unit will be on for one second
and then the unit will exit the setup mode and switch to the working mode (the
Blue light will start flashing).
You can now use your Midland BTMESH with the GPS for street voice an-
nouncement.
How to listen to the FM Radio
The FM Radio receiver is integrated inside the unit. You just need to switch to
the “FM Radio” mode in order to use it.
Long press the middle button until you hear “FM radio” from the voice an-
nouncement. Now all the three main buttons are dedicated to the FM Radio
(See Table C).
Press short the “Forward” or the “Backward” button to seek the FM Radio
station. When you press long the Forward or the Backward button, you can
scan up or down the 6 recorded stations.
A voice announcement will tell you the number of which memory you are en-
tering.
To save the station you are listening to, press the Forward and Backward but-
tons together for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the latest recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal
available for the radio station you like to listen to.
The RDS system is OFF by default, if needed you can toggle on/off the RDS
pressing together the “” and “Volume –” buttons for 3 sec when the
radio is on. A voice announcement will tell you the RDS status.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the “Setup” mode: turn off the unit and hold down the “Middle” but-
ton about 7 sec., until the Red light is on permanently.
› Press “Middle” and “” buttons together for 3 seconds. The blue
LED will flash three times.
C - Radio FM mode
Mode
Forward button
Middle button
Rear button
FM Radio
Short press:
seek station up
Long press:
Scan recorded
Double click:
Open/Close Intercom
Short press:
On/off
Long press:
Change mode
Double click:
Open/Close Mesh
Short press:
seek station up
Long press:
Scan recorded
Double click:
Open/Close Intercom