to the operator without interfering with the movements necessary for safe operation of the vehicle.
Set the proper position in the car to install the transceiver using the supplied supporting bracket
or eventually the slide bracket. Tighten the retaining screws. The fixing bracket must be close to
metallic parts.
POWER SUPPLY
Be sure the transceiver is off. In the direct-voltage power supply, to observe the polarity is very
important, even if the unit is protected against the accidental inversion:
Red = positive pole (+)
Black = negative pole (-)
The same colors are present on the battery and in the fuse box of the car. Connect correctly the
cable terminal to the battery.
INSTALLING AN ANTENNA
1. Place the antenna as high as possible.
2. The longer the antenna, the better will be the performance.
3. If possible, mount the antenna in the center of whatever surface you choose.
4. Keep antenna cable away from noise sources, such as the ignition switch, gauges,etc.
5. Make sure you have a solid metal-to-metal ground connection.
6. Prevent cable damage during antenna installation.
WARNING. to avoid damage, never operate your CB radio without connecting a proper
antenna. A periodical control of the ROS is recommended.
HOW TO OPERATE WITH YOUR TRANSCEIVER
1. Screw the microphone plug into the microphone jack.
2. Make sure your antenna is securely connected to the antenna connector.
3. Make sure the SQUELCH control is turned fully conterclockwise.
4. Turn on the unit and adjust the volume control.
5. Select your desired channel through the “UP/DN” buttons on the microphone.
6. To transmit, press the PTT button and speak with a normal tone of voice.
7. To receive, release the PTT button.
SPECIFICATIONS
GENERAL
Channels .............................................................................................................. 80 FM / 12 AM
Frequency Range ..................................................................................... 26.565 to 27.405 MHz
Frequency Control ................................................................................................................. PLL
Operating Temperature Range .................................................................................. -10
°
/+55
°
C
DC input voltage .................................................................................................. 13.2 Vdc
±
15%
Size .................................................................................................. 150(L) x 45(H) x 175(D)mm
Weight .................................................................................................................................... 1Kg
RECEIVER
Receiving system .................................................................... Dual conversion superheterodyne
Intermediate frequency ............................................................... I
°
IF:10.695 MHz II
°
IF:455 KHz
Sensitivity ................................................................................. 0.5
µ
V for 20dB SINAD in AM/FM
Audio output power @10% THD ......................................................................... 2.0 W @ 8 Ohm
Audio distortion ........................................................................................ Less than 8% @ 1KHz
Image rejection .................................................................................................................... 65dB
Adjacent channel rejection ................................................................................................... 65dB
Signal/Noise ratio ................................................................................................................. 45dB
Current drain at stand/by .................................................................................................. 250mA
TRANSMITTER
Output power .................................................................................... 4W FM-1W AM@ 13.2 Vdc
Modulation ................................................................................................. FM:1.8 KHz
±
200 Hz
........................................................................................................................... AM: 85% to 95%
Frequency response .......................................................................................... 400 Hz
÷
2,5 KHz
Output impedance .................................................................................. RF 50 Ohm unbalanced
Signal/Noise Ratio ....................................................................................................... 40 dB MIN
Current drain ................................................................................. 1100 mA (without modulation)
All specifications are subject to change without notice.
4
5
