10
HARDWARE INSTALLATION
Be certain to follow standard anti-static procedures when handling any of Midian’s products.
F3021, F3023, F4021, F4023:
Open the radio’s TX path by opening the MIC jumper, open the RX path by opening the DISC jumper, and open
the PTT path by opening the PTT jumper.
The unit plugs into the options connector J5 located under the options door located behind the battery. Plug the
GPS antenna cable FL connector into P6 of the GPS-2 IC2 board. Reassemble radio.
F3161, F4161:
Open the radio’s TX path by opening the MIC jumper, open the RX path by opening the AFOUT jumper, and open
the PTT path by opening the PTT jumper.
The unit plugs into the options connector J1, located just below the DSP connector. Plug the GPS antenna cable
FL connector into P6 of the GPS-2 IC2 board. Reassemble radio.
F5061, F6061:
Open the radio’s TX path by opening the “A” jumper, open the RX path by opening the “B” jumper, and open the
PTT path by opening the “C” jumper, if Mod 1476 is installed
do not open jumper C.
The unit plugs into the options connector J1 located on the main board of the radio. Plug the GPS antenna cable
FL connector into P6 of the GPS-2 IC2 board. Connect SMA to externally mounted GPS antenna. Reassemble
radio.
F9511:
Open the radio’s TX path by opening the “A” jumper, open the RX path by opening the “B” jumper, and open the
PTT path by opening the “C” jumper, if Mod 1476 is installed
do not open jumper C.
The unit plugs into the options connector J2 located on the main board of the radio. Plug the GPS antenna cable
FL connector into P6 of the GPS-2 IC2 board. Connect SMA to externally mounted GPS antenna. Reassemble
radio.
