Service manual for Wash and Dry Combo product
Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－
15
－
Code
How to test
t02
When “t02” is displayed on LED, “Error code check” function can be activated by pressing
the “Start/Pause” button. Then the latest error code will be displayed on LED. You can
check all 10 error codes at most by turning the knob to show the code one by one. “E00”
will be
t03
When “t03” is displayed on LED, “Software Version check” function can be activated by
pressing the “Start/Pause” button. the display will show “UL” and “001” in turn; press the
“Start/Pause” button again the display will show “cod” and software version cod in turn;
press the “Start/Pause” button the third time, “Inv” and inverter software version code
will be showed on the display in turn
t04
When “t04” is displayed on LED, “Display check” function can be activated by pressing
the “Start/Pause” button. All LED will be displayed one by one in a pre-set sequence.
t05
When “t05” is displayed on LED, “Pump check” function can be activated by pressing the
“Start/Pause” button. Then “P” will be displayed on LED. And pump will drain the water
out of the drum. Until there is no water in the machine.
t06
When “t06” is displayed on LED, “Water Switch check” function can be activated by
pressing the “Start/Pause” button. The water valve will be opened. And water level will be
showed on the display in data simultaneously.
t07
When “t07” is displayed on LED, “Water Heater check” function can be activated by
pressing the “Start/Pause” button. The LED will display current temperature of sensor.
Press the “Start/Pause” button to start check. The water valve will be opened and stop at
water Level 01. Then the heater will start and stop 5 minutes later. The LED will display
the temperature value changes if the heater works well.
t08
When “t08” is displayed on LED, “air heater” function can be activated by pressing
the “Start/Pause” button. The fan will work and display will show “dry”, at the same
time, the fan starts to work. The inlet and outlet air temperature will be showed in
the mode of “IN” and “OUT” in turn.
t09
When “t09” is displayed on LED, “Wash check” function can be activated by pressing the
“Start/Pause” button. The LED will display “tt”.The drum will run at
45rpm with sequence: spin in counter-clockwise 5 seconds, stop for 3 seconds, spin
in clockwise 5 seconds, stop for 3 seconds and repeat that cycle for 8 minutes, then
the unit will stop.
