Service manual for Wash and Dry Combo product
Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－
13
－
Leveling the washer
1. When positioning the washing machine, please first check if the legs are closely attached to
the cabinet. If not, please turn them to their original positions with hand or wrench and tighten
the nuts with wrench.
2. After positioning the washing machine, press four corners on top cover of washing machine in
sequence. If the washing machine is not stable when being pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing machine. Loosen the lock nut with wrench and turn
the leg with hand until it closely contacts with the floor. Press the leg with one hand and fasten
the nut closely to the cabinet with the other hand.
4. After being locked properly, press four corners again to make sure that they has been adjusted
properly. If it is still unstable, it has to repeat Steps 2 and 3.
5. Use the carpenter’s level to check whether the unit is leveled in two direction. If not, steps 1~3
should be repeated to make the bottom legs closely against the ground and the nuts shall be
locked tightly.
.
Power on the unit and have a test operation
Connect the power to a socket which is correctly installed and properly earthed.
Open all faucet for water inlet.
Close the door of the unit.
Power on the unit Select the Rinse&Spin cycle for test operation. Then press the Start button for
test.
