Middleby Marshall PS360E Series, Owner'S Operating & Installation Manual

Page: 29 / 60

SECTION 2
INSTALLATION
29
5. If it is necessary to add or remove conveyor links
to achieve the correct tension, OR if it is necessary
to reverse the conveyor belt for correct orientation,
the belt will need to be removed from the conveyor
frame. If this is necessary, perform the following
procedure:
− Remove the conveyor assembly from the
oven and place it flat on the floor.
−
Remove the master links using long-nose
pliers. Then, roll up the belt along the length
of the conveyor frame.
−
Add or remove belt links as necessary to
achieve the correct belt tension.
− Replace the belt on the conveyor frame.
Check that the conveyor belt links are oriented
as shown in Figure 24, and that the smooth
side of the conveyor belt faces UP.
− Connect the inside master links. Check that
the links are oriented as shown in Figure 24.
−
Connect the outside master links. Note that
the outside master links each have an open
hook on one side. This hook aligns with the
hooks along the sides of the other conveyor
links. See Figure 24.
−
Replace the conveyor into the oven.
Conveyor and Master Link
Orientation
Final Assembly
1. Install the crumb trays underneath the conveyor
as shown in Figure 25.
Crumb Trays
Conveyor Belt Reversal
Conveyor belt reversal consists of two steps:
1. Resetting the conveyor gear-motor direction
through the User Interface.
2. Switching the photo sensor to the new entrance.
RESETTING DIRECTION
1. Enter SYSTEM CONFIGURATION menu.
Press key. “PASSWORD” will appear on
the screen.
Press and . The
screen should appear as below.
2. Arrow down to BELTS menu (flashing). Press
.
Screen will appear as below:
DIR: should be flashing. Press then press
arrow up to change direction. Press to
accept the direction change.