Microtronics 305001, User Manual

Page: 23 / 127

Chapter 5 General specifications
Note: This device is exclusively intended to be used for the purposes as described above.
Any other use or use beyond what is specified or a modification of the device shall be
deemed to be not for the intended purpose and is not permitted without the express written
consent of the manufacturer. The manufacturer shall not be held liable for any damages that
may result from such unauthorised use or modification. The operator alone bears the
associated risk.
Note: The manufacturer is not liable for data loss of any kind if the device is damaged and
data is not able to be stored correctly.
Note: The integrated SIM chip provides a mobile communications connection to a variety of
international service providers. In order to be able to utilise all functions of the device, you
must ensure that the device is located in the service area of one of these service providers.
You can find a list of all supported countries and associated service providers under
www.microtronics.at/footprint. A Managed Service contract with Microtronics Engineering
GmbH is required for use of the mobile data transmission (see
www.microtronics.at/managedservice). This includes the provisioning of the mobile
communications connection via the network of the service provider included in the above-
mentioned list.
5.8 General product information
The device is a compact, portable ATEX data logger for recording and transferring analogue and
digital signals. There are 2 universal inputs available, which can be operated in various analogue
and digital modes. The device operates without mains power and has a 22,5 VDC voltage output to
supply the sensors. To save energy, the voltage output can be configured in such a way that it is
only activated just before and during a measurement. In addition to the measurement data of the
universal inputs, the internal "Battery", "GSM level" and "Int. temp" measurement values are
determined (see "Internal channels" on page 78). All of the generated measurement data is
temporarily saved on an internal data memory and is then wirelessly transferred to a central location
at a freely selected interval. The device is also configured via this connection. The device is
equipped with an integrated SIM chip.
5.9 Device labelling
The specifications in this manual only apply to device types myDatalog2Ex Opt2 and myDatalog2Ex
Opt2. The type plate is located on the rear side of the device and contains the following
specifications:
l
Type designation
l
Serial number
l
CE marking
l
Protection class
l
Environmental conditions during operation
l
Ex protection designation as specified in chapter "Declaration of conformity" on page 9
l
Hardware revision
Rev. 02 23