If all segments of the display are on after
installation you have entered the display
test mode accidentally. Please try again
until the display reacts normally.
5.2. Changing of the puck battery
Remove the wheel from the frame accord-
ing to your skate manual. Open the four
screws of the puck with a small screw-
driver. Open the case and remove the
CR 1632 battery carefully. Insert the new
battery with + facing up and replace the
cover in the proper position. Fix the cover
with the screws.
If you are using the “Battery Service Kit”
for changing the batteries we recommend
you replace the o-rings of the puck case as
well. Also please use the small o-rings for
the screws for improved water resistance.
o-rings and screws for maintaining the
water resistance, a small screwdriver and
an instruction manual.
You can get the “Battery Service Kit” in
your local sports store or by contacting
our service-team (see last page).
ATTENTION!
Empty batteries should NOT be thrown
away. Please check your local regulations
before dumping the batteries.
The bracelet of your skate speedometer
contains a part of the antenna. Please
handle the bracelet with care to avoid
antenna damage which could lead to a
failure of your In-Line Skate Speedometer.
Open the Watch Case Cover and carefully
remove the old battery from the battery
clip by unscrewing the clip. Insert the new
battery of the type CR 1632 with + facing
up and reinstall the battery clip. Close the
back cover of the watch with the screws
again. To check that the installation has
been successful press
MODE
.
Microsport_Basic_11/02 11.11.2002 15:16 Uhr Seite 71
