Microsensor MFE600H Series, Operation Manual

Page: 20 / 30

19
7 Current output Choose
Flow output
、
Heat output
Cooling output
、
Cold and heat output
8 Heat range setting Setting
9 Cooling range setting Setting
10 Pulse output method Choose
Flow frequency output Hz, Flow pulse
L, Flow pulse m
³
Heat pulse MJ, Heat
pulse GJ, Heat pulse KWh, Cooling
output MWh, Cooling pulse MJ,
Cooling pulse GJ, Cooling pulse KWh,
Cold and heat output MWh, Heat and
cooling pulse MJ, Heat and cooling
pulse GJ, Heat and cooling pulse
KWh, Cooling and heat output MWh
11 Output pulse coefficient Setting
12 Flow meter location Choose Flow inlet
、
Flow outlet
13
Heat meter to measure
water temperature
Setting 0
～
199.9
14
Cooling meter to measure
water temperature
Setting 0
～
199.9
15 Working pressure selection Choose 0.6MP/1.6MP
16 Inlet PT check 1
Access standard
resistance 1
Automatic correction
17 Inlet PT check 2
Access standard
resistance 2
Automatic correction
18 Outlet PT check 1
Access standard
resistance 1
Automatic correction
19 Outlet PT check 2
Access standard
resistance 2
Automatic correction
20 Thermal resistance type Choose Pt1000 Pt100
21 Simulation mode Choose Enable/Disable
22 Entry temperature setting Setting 0
～
199.9
23 Export temperature setting Setting 0
～
199.9
24 Test flow rate setting Setting 0
～
19.999
25 Total heat preset Choose
26 Total cooling capacity preset Setting
27 Calibration mode Choose Enable/Disable
The meter needs to set the operating parameters correctly to make the meter run in the best state and
obtain higher measurement display accuracy and measurement output accuracy
。
7 Introduction to some parameters of instrument energy meter
7.1 Flow parameter
7.1.1 Instrument working mode
The electromagnetic flowmeter heat meter has three working modes: Heat working mode, Cooling
working mode, heat and cooling working mode.