Microscan HAWK MV-4000, Manual

Page: 110 / 142

Appendix F
Serial Commands
F-4 HAWK MV-4000 Smart Camera Guide
JOBDELETE {[-slot=]n|-all}
Deletes job in slot n , or all jobs if -all .
Important: Does not delete the current job loaded in camera memory.
JOBDOWNLOAD <-transfer={ymodem|ftp}> [-size=value] [-c]
Important: This command is only supported over TCP/IP for the HAWK MV-4000.
Downloads a .avz job file via the specified transfer method (ymodem supported only over
RS-232; FTP supported only over network connection).
The
ymodem transfer method only requires that the user send the .avz file via the ymodem
protocol over RS-232, and the job will load automatically after the transfer is complete.
The
FTP transfer method requires the user to perform the following steps to load the job:
• JOBDOWNLOAD: -transfer=ftp [-size=avpsizeinbytes]
Pre-creates a fixed-size /streamd0 RAMdisk to receive the .avz over FTP. If size is omitted,
the default RAM disk size is used to create /streamd0. The size of /streamd0 is limited to
(available contiguous RAM – minimum target contiguous RAM) / 2.
• User FTPs the job to /streamd0
•
JOBLOAD: -mem -r
Loads .avz from /streamd0 into RAM, deletes the RAMDisk /streamd0, and optionally
starts the job (if -r is specified).
JOBINFO [[-slot=]n] [-v]
Gets job summary or info about slot n .
JOBINFO with no arguments returns a list of all jobs on the device.
-v = Verbose n . This option shows the amount of space that would be freed if the job were
deleted. It also lists the total disk space and free disk space.
JOBLOAD {[-slot=]<n>|-mem} [-r]
Loads a job from slot n or from memory when used with the JOBDOWNLOAD command
via FTP.
-r = Start inspections.
JOBSAVE [-slot=]<n>
Saves current job to slot n .
MEMAVAIL [-cp]
Returns available memory for device or coprocessor.
MEMCONTIG [-cp]
Returns maximum memory block for device or coprocessor.