Micros Systems PCWS 2015, Setup Manual, Page: 139 / 178

PCWS 2015 Setup Guide - 2nd Edition 4-19
Installing and Operating the Workstation 2015
Operation
Image Recovery
The following general procedures can be used for PCWS 2015 Windows 7 or
POSReady 2009 Recovery CF Card when available. How you start the
optional Recovery CF is dependant on the System Board Revision and the
BIOS installed.
• Revision D System Boards with BIOS Version O1301g or later can use the
Recovery Button located on the bottom of the unit to start the Recovery CF.
BIOS O1301g or later also supports the optional entry of a password to
start the Recovery CF. See Chapter 3 to setup a Supervisor password.
• Revision C System Boards with the O1301 BIOS can support the Recovery
CF through the[F5] boot menu option.
• Revision C System Boards with the O1201r BIOS can support the
Recovery CF if you manually change the BIOS Boot Order to boot from
the Recovery CF.
General Notes on the Recovery CF
• In all cases, the Recovery CF should not be ‘hot-swapped’. When installing
or removing a Recovery CF, the power down the workstation.
• The optional Workstation 5A Recovery CF is not compatible with the
PCWS 2015 hardware.
Revision D System Board - BIOS Version O1301g
This combination of System Board and BIOS supports the Recovery Button
located on the bottom of the workstation.
• With the Recovery CF installed, press the recovery button when the
workstation is powered down, but connected to a functional AC power
source. This is also known as the ACPI S5 or ‘Soft-Off’ state.
• Power up the workstation with the power button.
• The workstation will power up for 4 seconds, (display is blank), shut
down for 2 seconds, then power up.
• Splash screen appears, then clears.
• A password prompt appears if you configured a Supervisor password in
BIOS Version O1301g or later.
• The workstation should boot from the Recovery CF, perform the image
recovery, restart the workstation and boot from the primary boot media,
normally a SATA hard disk or RAID config.