Compact Numeric Keypad - MP3393
Page 6 of 9
T_MP3393-Compact Numeric Keypad Leaflet_V1.3
Summary of Key function description
Key:
...............
Name:
............
Operation:
1-9 .................. ...................... Digit entry for S1-S7 and other parameters.
←/ →
.............. Move focus .... With NumLock off, move focused (red) zone left/right.
↑ / ↓
............... Move focus .... With NumLock off, move focused (red) zone up/down.
+ / - ................ Change value . Increment / Decrement value of focused parameter.
DEL ................ Turn Off .........
Use Shift + “.” Turns off focused parameter–Decr-auto/Sync-to/S2-S7; Pause->repeat,
Train->Infinite.
INS ................. Insert/Edit.......
Use Shift + “0” Restores focused parameter from DEL; Edits parameter where allowed.
END ................ Auto Lock .......
Use Shift + “0” Master on/off toggle for all automatic decrementation.
PACE
............. Pace .............. Brief press toggles pacing On / Off; prolonged (>300ms) press paces only while pressed.
PGUP/PGDN .. Stim Page ......
Use Shift + “9” or “3” Flips between Stim Page A and B.
ESC ................ Escape ........... Exits from menus and returns focus to Protocol-specific screen Home position.
BSP
←
........... Undo .............. Step back in decrementation to previous value
– in SNRT, Nodal_ERP, Multi_Sx.
Table 1: Key function description
Re-Installation of Standard Keyboard
1. Disconnect the Numeric Keypad PS/2 connector and connect the Standard Keyboard.
Troubleshooting
Symptom
Potential Cause
Remedy
Enter key toggles pacing
On/Off
‘Config Service Var 20 Enable
Keypad Input’ has been
incorrectly set to ‘1’
Config Service Var 20 “En
Keypad Input” should not be
used. Set it to ‘0’ for both
Keypad or Keyboard input.
To correct, use the Standard
Keyboard and press “k” to
enter the User Config Menu
(password ‘henry’). Then press
PgDn for the Service menu
(‘service’). CSV20 is at the
lower left. Set it to ‘0’ and exit.
Engaging touchscreen buttons
and entering numbers
occasionally toggles pacing
On/Off
You are using the Numeric
Keypad with Software 3.21 and
have Service Configuration
Variable 20 Enable Keypad
incorrectly set to ‘1’
Set CSV20 to ‘0’ or contact
your Distributor.
Keypad does not work
Disconnection at extension
cable or at PC
Check and reconnect.
Keypad keys behave
unexpectedly
– arrows instead
of digits or vice versa
NumLock is disengaged or
engaged.
Keypad behaves as a standard
PC input device.
NumLock On: Numeric input
enabled.
NumLock Off: Arrow input
enabled.
Engage NumLock and ensure
the LED indicator is on or off as
desired.