grifco.com.au
grifco.co.nz
WIRELESS KEYPAD – MODEL E840G
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving door:
•
Install Wireless Keypad within sight of the door, out of reach of children at a minimum height of 1.5m, and away
from all moving parts of door.
•
ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote
controls.
•
Ac vate door ONLY when it can be seen clearly, is properly installed, and there are no obstruc ons to the door travel.
•
ALWAYS keep the door in sight un l completely closed. NEVER permit anyone to cross the path of a moving door
•
NEVER allow small children near ba eries. If ba ery is swallowed, immediately no fy your doctor.
GRIFCO FRONT PANEL
1.
UP
- Moves the door upwards
2.
DOWN
- Moves the door downwards
3.
STOP
- Stops the door
4.
SET
-
5.
POWER ON
- Shows when the unit is
mains powered
6.
STATUS
- Shows the status of the unit
7.
LIMIT ERROR
– When lit indicates limits
are not set
PROGRAMMING - 2.0
To program the
E840G
Wireless Keypad ensure the radio lock is
removed then perform the following steps:
1. Press and hold the
SET
bu on on the GRIFCO front panel,
then
2. While holding the
SET
bu on, press the
STOP
bu on 5 mes
(the
green
status light will light then con nue
fl
ashing,
indica ng learn mode)
3. Let go of the
SET
bu on
4. Enter a 4-digit code into the
E840G
keypad.
5. Press the
E840G
ENTER
key
6.
Press
STOP
bu on on the GRIFCO front panel to exit learn
mode.
7.
Install the
RADIO
LOCK
key on the eDrive2 board to prevent
any further wireless entry devices being learned.
E840G Wireless Keypad
ENTER key
KEYPAD
1. Press the learn bu�on
on the main PCB
2. Enter a 4-digit code on
the E840G keypad and
press enter
3. The operator will auto
exit learn mode
PROGRAMMING - S-Drive
Learn Button
Indicator LED
PROGRAMMING - LS-Drive
1. Press the learn bu�on on the rear of
the operator
2. Enter a 4-digit code on the E840G
keypad and press enter
3. The operator will auto exit learn mode
PROGRAMMING - LR-Drive
“S” Button
1. Press & Release the “S” Bu�on on the operator
2. Enter a 4-digit code of your choice on the Wireless Keypad
3. Press & hold the Enter Bu�on on the Wireless Keypad un�l
the operator light flashes
4. A�er the lights flash release the Enter Bu�on
