MicroNet SP3524A, User Manual

Page: 9 / 76

6
All Home network connections to VDSL
1 X RJ-21 Cable (Male to Male) Using Pin 1 ~ 24, 26 ~ 49
RJ-21 Pin25 & 50 is not used.
The setup of the Managed Switch can be performed using the following steps:
Step 1: Connecting to Gigabit Ethernet
The 24-port VDSL managed switch has 2 x GIGA Ethernet supporting full or
half-duplex operation. The transmission mode is using auto-negotiation.
Therefore, the devices attached to these ports must support auto-negotiation
unless they will always operate at half duplex. If transmissions must run at full
duplex, but the attached device does not support auto-negotiation, then you
should upgrade this device to a newer version that supports auto-negotiation.
Use “25” port connect to devices such as server, bridge or router. You can
also cascade to another compatible MUX or hub by connecting the 26 port to
the other device.
y
Connect a RJ-45 Ethernet cable from a network switch to an available
Ethernet port on SP3524A.
y
The network switch should provide 10/100/1000 Mbps Giga Ethernet ports
that are connected with SP3524A and uplink port for a network connection.
Step 2: Connecting to RJ-21 VDSL LINE port for VDSL Modem (SP3501AS)
connections.
Step 3 : Connecting to RJ-21 POTS/ISDN port for central office switch or PBX connections.
Step 4 :
y
RJ-21 Cable to Main Distribution Frame (MDF) for connecting telephones
line and VDSL Modem (SP3501AS) connections lines
y
The RJ21 cable is suitable for customers who have their own MDF(Main
Distribution Frame).
Step 5 : Connect the lines from VDSL Modem (SP3501AS) to the MDF.
Step 6: Connect the lines from the central office switch or PBX to the MDF.