25
4.7. Port Controls
This section shows you how to change every port status and speed mode.
1. State:
User can disable or enable this port control.
2. Negotiation:
User can set auto negotiation mode is Auto, Force of per
port, Nway (specify the speed/duplex on this port and
enable auto-negotiation).
3. Speed:
User can set 5Mbps / 15Mbps / 25Mbps for port 1 ~ 24.
1000Mbps, 100Mbps or 10Mbps speed for Port25 ~ Port26.
4. Duplex:
User can set full-duplex or half-duplex mode of per port.
5. Flows
control:
Full:
User can set flow control function is enable or
disable in full mode.
Half:
User can set backpressure is enable or disable in half
mode.
6. Rate
Control:
24 ports VDSL MANAGED SWITCH, port 1 ~ port 24,
supports by-port ingress and egress rate control. For
example, assume Port 1 is 10Mbps, users can set it’s
effective egress rate is 1Mbps, ingress rate is 500Kbps.
MANAGED SWITCH will be performed flow control or
backpressure to confine the ingress rate to meet the
specified rate.
Ingress:
The valid range is 0 ~ 100 (100 = 10Mbps).
The unit is 100K. 0: disable rate control.
Egress:
The valid range is 0 ~ 100 (100 = 10Mbps).
The unit is 100K. 0: disable rate control.
Summary of Contents for SP3524A
