33
(Macintosh) The icon for my drive does not appear on the desktop after system start-up, even
though the drive is receiving power and can be seen in the disk utility software.
•
Turn on your drive during Macintosh start-up, rather than before.
This procedure is sometimes necessary due to the differences among SCSI controller chips.
A module won’t come out of the DataDock.
•
Push the module into the DataDock until you hear its latch release, then try removing the module.
The DataDock’s temperature light is flashing and the alarm is sounding.
•
Make sure that the fan is operating and free from obstructions.
If the fan is not operating, turn off the DataDock and contact MicroNet Technical Support.
•
Check that the air vent slots at the front and side of the DataDock are free from obstruction.
•
Remove each module to see if the temperature alarm stops. If the alarm stops as a module is
removed, the module is too hot.
!
If the alarm continues to sound after both modules are removed, the DataDock itself, is too hot.
Turn off the DataDock and contact MicroNet Technical Support.
Getting Help
If you should experience any problems with your DataDock system, please contact MicroNet’s Technical
Support team for assistance.
MicroNet Technology, Inc.
Technical Support Department
51 Discovery
Irvine, California 92618
Phone:
(949) 453-6060
Fax:
(949) 453-6061
BBS:
(949) 453-6063
Internet:
http://www.micronet.com
E-mail:
